Ametek Sorensen XG 60-14 User Manual

PROGRAMMABLE POWER
M370430-01 Rev F www.programmablepower.com
XG Family Programmable DC
Power Supply
Operating Manual
(firmware v 2.0 and higher)
670 Watts – 1700 Watts
Half Rack
Full Rack
6 V to 600 V Models:
6-110
6-220
6-220
8-100
8-187.5
8-200
12-70
12.5-120
12-140
20-42
20-76
20-84
33-25
30-50
33-50
40-21
40-38
40-42
60-14
60-25
60-28
80-10.5
80-19
80-21
100-8.5
100-15
100-17
150-5.6
150-10
150-11.2
300-2.8
300-5
300-5.6
600-1.4
600-2.6
600-2.8

Ametek Sorensen XG 60-14 Specifications

General

Output Voltage	0-60 V
Output Current	0-14 A
Power Rating	840 W
Output Type	DC
Programmability	Yes
Cooling	Forced air
Input Voltage	100-240 VAC
Input Frequency	47-63 Hz
Operating Temperature	0 to 50 °C
Protections	Over Voltage, Over Current, Over Temperature
Interface	RS-232
Storage Temperature	-20 to 70 °C
Efficiency	>85% typical

Summary

Installation

Basic Setup Procedure

Summary of the steps required for basic power supply setup and installation.

Step 3: Connecting AC Input Power

Instructions for safely connecting the AC input power to the power supply.

Step 5: Performing Functional Tests

Procedures for performing functional checks and tests on the power supply.

Local Operation

Alarms and Errors

Details on various alarm conditions and error messages that can occur.

Using Over Voltage Protection (OVP)

Explanation of the Over Voltage Protection feature and its configuration.

Analog Programming (APG) and Isolated Analog Programming (ISOL)

Analog Programming (APG) of Output Voltage and Output Current

How to control output voltage and current using analog input sources.

Isolated Analog Programming Mode (ISOL)

Information on using the isolated analog programming interface for control.

Remote Operation

Hardware and Connection Setup

Guidance on setting up hardware and connections for remote interfaces.

Status Reporting in SCPI

Explanation of the SCPI standard for status reporting.

Reset Command

Communications Options

SETTING UP LAN/ETHERNET

LOCAL AREA NETWORK (LAN) OPTION

Calibration and Troubleshooting

Main Voltage and Current Calibration Principle

Calibrating the Output Voltage

APPENDIX A SCPI Command Reference

Using SCPI Commands

SCPI Command Summary

APPENDIX B Error Messages

Command Error List

Execution Error List