Ametek Sorensen XG 60-28 User Manual

PROGRAMMABLE POWER
M370430-01 Rev F www.programmablepower.com
XG Family Programmable DC
Power Supply
Operating Manual
(firmware v 2.0 and higher)
670 Watts – 1700 Watts
Half Rack
Full Rack
6 V to 600 V Models:
6-110
6-220
6-220
8-100
8-187.5
8-200
12-70
12.5-120
12-140
20-42
20-76
20-84
33-25
30-50
33-50
40-21
40-38
40-42
60-14
60-25
60-28
80-10.5
80-19
80-21
100-8.5
100-15
100-17
150-5.6
150-10
150-11.2
300-2.8
300-5
300-5.6
600-1.4
600-2.6
600-2.8

Ametek Sorensen XG 60-28 Specifications

General

Model	XG 60-28
Output Voltage	0-60 V
Output Current	0-28 A
Power Rating	1680 W
Output Type	DC
Frequency	47-63 Hz
Operating Temperature	0 to 50 °C
Storage Temperature	-20 to 70 °C
Cooling	Forced air
Protections	Overvoltage, Overcurrent, Overtemperature
Remote Sensing	Yes
Communication Interface	RS232, USB, GPIB (optional)

Summary

Safety

Standard Warnings

Presents critical safety instructions and warnings to ensure safe installation and operation of the power supply.

2 INSTALLATION

Basic Setup Procedure

Outlines the sequential steps for basic power supply installation, including inspection, mounting, and connections.

Connecting AC Input Power

Explains how to safely connect the AC input power to the power supply unit, covering different models.

Selecting Load Wires

Offers recommendations for selecting appropriate load wires based on current carrying capacity and insulation rating.

Connecting Loads

Describes how to connect single and multiple loads to the DC output connectors, including safety precautions.

3 LOCAL OPERATION

Front Panel Configuration and Operation

Guides users through front panel settings, menu navigation, mode selection, and display behaviors for local control.

Protection and Alarm Features

Details alarm management, foldback, OVP, UVP, OCP, OTP, external shutdown, loop protection, and interlock functions.

4 Analog Programming (APG) and Isolated Analog Programming (ISOL)

Analog Programming (APG) of Output Voltage and Output Current

Isolated Analog Programming Mode (ISOL)

5 REMOTE OPERATION

Hardware and Connection Setup

Configuring Remote Control Using RS-232

Provides step-by-step instructions for configuring remote control via RS-232 interface.

Configuring Remote Control Using RS-485

Details the process of setting up remote control communication using the RS-485 interface.

Configuring Remote Control using the USB Connector

6 COMMUNICATIONS OPTIONS

SETTING UP LAN/ETHERNET

LOCAL AREA NETWORK (LAN) OPTION

7 CALIBRATION AND TROUBLESHOOTING

Main Voltage and Current Calibration Principle

Calibrating the Output Voltage and Current

Troubleshooting for Operators