To Next PageTo Next Page
Need help?Do you have a question about the Ametek Sorensen XG 20-84 and is the answer not in the manual?
General| Brand | Ametek |
|---|---|
| Model | Sorensen XG 20-84 |
| Category | Power Supply |
| Language | English |
Explains Constant Power mode operation and activation.
Details conditions causing alarms and the alarm order of precedence.
Methods for clearing triggered, manual, and flash failure alarms.
How to disable alarms by masking them, preventing SCPI detection.
Defines how alarm output latch affects output state upon alarm clearing.
How foldback mode disables output during mode transitions.
How OVP protects the load and how to set trip points.
Procedure to define the Over Voltage Protection set point.
How UVP prevents voltage settings below a set value.
Procedure to define the Under Voltage Protection set point.
OCP alarm configuration, behavior, and latency.
OTP lock mechanism to protect against overheating.
Enables or disables output via a logic level signal.
How to define the polarity for the external shutdown signal.
Feature to enable/disable multiple units in daisy chain configuration.
Steps to set up loop protection for multiple units.
How the interlock function enables or disables power supply output.
Programming preset for output voltage and current.
Alarms indicating hardware malfunctions with error messages.
Lists settings saved and recalled on a power cycle event.
Describes three memory locations for storing frequently used configurations.
Procedure to save user setting memory locations via front panel or SCPI.
Feature to recall previously saved user setting memory locations.
Feature to lock the front panel, preventing accidental changes.
Procedure to reset the power supply to factory default settings.
Guidance on operating power supplies in series or parallel configurations.
Steps to connect multiple supplies in series to increase output voltage.
How to connect parallel power supplies in local sensing mode for current sharing.
How to connect parallel power supplies in remote sensing mode.
Steps to activate APG voltage mode using external voltage source.
Steps to activate APG current mode using external voltage source.
Steps to activate APG voltage mode using an external resistor.
Steps to activate APG current mode using an external resistor.
Information about rear panel connectors for ISOL programming.
Steps to activate ISOL voltage mode using external voltage source.
Steps to activate ISOL current mode using external voltage source.
Steps to activate ISOL voltage mode using an external resistor.
Steps to activate ISOL current mode using an external resistor.
Information on setting up hardware for remote interfaces (RS-232, RS-485, USB, GPIB).
Steps for setting up a terminal program for serial communication.
Overview of SCPI status reporting requirements and XG implementation.
Describes the structure of SCPI registers used for status reporting.
Details the 16-bit register for normal operation conditions.
Details IEEE 488.2 registers for status reporting.
Describes the Status Byte register content and how to read it.
Indicates if OSR bits are set and their corresponding enable bits are true.
Allows selection of reasons for the power supply to issue a service request.
Sets bits for specific events during power supply operation.
Performs a device reset to a known state independent of past use.
Clears all Event Registers, Status Byte, SESR, and Error Queue.
Configures status data structures to ensure events are reported at a higher level.
Provides help on available commands and their syntax.
Prevents front panel buttons from functioning when the panel is locked.
Executes programs stored in power supply memory.
Loads programs into memory using START and STOP commands.
Procedure to save an Auto Sequence program to a text file on PC.
Procedure to store a command beyond a power cycle.
Commands to run stored auto sequence programs.
OTP alarm protecting against overheating, cannot be masked.
Enabling or disabling interlock feature via SCPI command only.
Procedure to calibrate the over voltage protection.
Steps to take in an emergency shutdown situation.
Steps to follow if the power supply displays unusual or erratic operation.
