Ametek Sorensen XG 60-25 User Manual

PROGRAMMABLE POWER
M370430-01 Rev F www.programmablepower.com
XG Family Programmable DC
Power Supply
Operating Manual
(firmware v 2.0 and higher)
670 Watts – 1700 Watts
Half Rack
Full Rack
6 V to 600 V Models:
6-110
6-220
6-220
8-100
8-187.5
8-200
12-70
12.5-120
12-140
20-42
20-76
20-84
33-25
30-50
33-50
40-21
40-38
40-42
60-14
60-25
60-28
80-10.5
80-19
80-21
100-8.5
100-15
100-17
150-5.6
150-10
150-11.2
300-2.8
300-5
300-5.6
600-1.4
600-2.6
600-2.8

Ametek Sorensen XG 60-25 Specifications

General

Output Voltage	0-60 V
Output Current	0-25 A
Power Rating	1500 W
Frequency	47-63 Hz
Input Frequency	47-63 Hz
Cooling	Forced air
Efficiency	88%
Operating Temperature	0°C to +50°C
Storage Temperature	-20°C to 70°C

Summary

Important Safety Instructions

WARNING: High energy and high voltage

Cautionary advice regarding high energy levels and potentially lethal voltages present in the power supply.

WARNING: Fire hazard

Advises operating the power supply in a safe environment and not making unauthorized modifications.

2 Installation

Step 3: Connecting AC Input Power

Provides instructions and safety precautions for connecting AC input power.

3 Local Operation

Alarms and Errors

Describes potential alarms, their precedence, and how they affect the power supply.

Using Over Voltage Protection (OVP)

Explains the function and configuration of Over Voltage Protection.

Resetting the Power Supply

Provides instructions for performing a soft reset to restore factory default settings.

4 Analog Programming (APG) and Isolated Analog Programming (ISOL)

5 Remote Operation

Hardware and Connection Setup

Information on setting up hardware connections for various remote interfaces.

Status Reporting in SCPI

Explains SCPI status reporting mechanisms and registers.

SCPI Error/Event Queue

Information on the error/event queue and how to query for errors.

Auto Sequence Programming

Details on creating, storing, and running automated sequences.

6 Communications Options

SETTING UP LAN/ETHERNET

Procedures for configuring LAN/Ethernet connections for remote control.

LOCAL AREA NETWORK (LAN) OPTION

Overview of the LAN option, including its capabilities and requirements.

Communication Configuration

Describes connection choices for remote control via LAN, direct PC, or private network.

Setting a Static IP Address through Ethernet, USB, Serial Interfaces

Instructions for setting static IP addresses for network interfaces.

SYSTEM COMMANDS

7 Calibration and Troubleshooting

Main Voltage and Current Calibration Principle

Calibrating the Output Voltage

Calibrating the Output Current

Over Voltage Protection Calibration

Non-isolated Analog Programming Calibration

Emergency Shutdown

Unusual or Erratic Operation

APPENDIX A SCPI Command Reference

SCPI Conformance Information

SCPI Command Hierarchy

Using SCPI Commands

Parameter Types

APPENDIX B Error Messages

Command Error List

Execution Error List

APPENDIX D Rack Mount Options and Installation Instructions

Rack Mount Kit Options

Mounting Option A: 1U Rails

APPENDIX E Lantronix Procedures for MEA Option

Assigning an IP Address to the Power Supply Unit

Terminal Configuration

Steps to configure terminal programs for communication with the power supply.

Troubleshooting for XG 850W Model with ENET and/or RS-485 Communication