4 Remove the check valve spacer, spring, valve poppet, and check valve o-ring.
5 Inspect the check valve o-ring, and replace it if necessary. Then re-install the o-ring, valve poppet, spring, and check valve spacer.
6 Slowly pump two and one-half strokes, positioning the pump lever at approximately 45 degrees, halfway through its stroke.
7 Allow system uid to ow out of the low pressure check valve, ushing entrapped air.
8 Examine the port for air bubbles which may adhere to the threads or parts.
Note: If air bubbles are present, repeat steps 2 through 5 until no more air bubbles appear.
9 Install the check valve plug and o-ring and tighten partially.
10 If installing the low pressure/high volume check valve plug... Tighten the check valve plug.
The procedure for the low-pressure/high volume side is now complete.
11 If installing the high pressure/low volume check valve plug... Use slight pressure on the hand lever to push system uid past the high
pressure/low volume check valve plug to ensure complete purging of the valve port.
12
Tighten the high pressure/low volume check valve plug.
13 Operate the pump handle until pumping becomes dicult.
14 Raise the pump handle to the top of its stoke.
15 Push in the valve rod selector to the high pressure/low volume position.
16 Resume pumping to verify the pump is operating properly.
Check Valve Spacer
Spring
Valve Poppet
Check Valve O-ring
To Next Page
Loading...
Need help?
General
