Ametek T Series - Spare Parts and Recertification

Support  26
Type T Hydraulic Deadweight Tester Operation Manual

FITTING KITS AND SPARE PARTS
Service Kits
X
T-1
T-250 .............Buna N rebuild kit
T-559
.............Viton rebuild kit
T
-326 .............EPT rebuild kit
Hoses
X
T-1
KH-18 ............Hose. 0.46 m 1/4" NPT male x 1/4" NPT male 700 bar / 10 000 psi.
Adapters
X
T-1
T-134 .............Union Body. 15/16-20 UNEF male x 1/4" NPT female.
T-135
.............Union Body. 15/16-20 UNEF male x 1/2" NPT female
.
T-186 .............Union Body. 15/16-20 UNEF male x 7/16" NPT female.
T-331
.............Union Body. 15/16-20 UNEF male x 3/8" NPT female
.
T-863 .............Union Body. 15/16-20 UNEF male x 1/8" NPT female .
T-786
.............Adapter. 1/4" NPT male x 1/4" BSP female.
T-787
.............Adapter. 1/4" NPT male x 1/2" BSP f
emale.
T-915
.............Quick Connector
. 1/4" NPT male.
T-916 .............Quick Connector Plug. 1/4" NPT male.

RECOMMENDED RECERTIFICATION PROCEDURES
All deadweight pressure testers produced by AMETEK, M&G are tested and certied in the M&G laboratory for accuracy of pressure produced, with results
traceable to the National Institute of Standards and Technology.
In addition, if ±0.025% or ±0.015% accuracy is required, data is furnished showing nominal and observed pressures within the upper 90% of the range of
each piston and cylinder, with results directly traceable to the National Institute of Standards and Technology.
Note: This data is optional on the ±0.010% units.
This accuracy can degrade with wear resulting from continued use and/or incidental damage. AMETEK, M&G recommends all instruments be periodically
retested for accuracy. Testers returned to AMETEK, M&G will be “Tested and re-certied with data furnished traceable to NIST.”