Setup 5
Type T Hydraulic Deadweight Tester Operation Manual
9 Align the union body (attached to the column) with the union nipple and nut on the front of the pump body.
10
Carefully nger-tighten the union nut t
o the union body.
Align the connecting hardware… then nger-tighten the union nut.
11 Ensure again that the column-to-pump connecting hardware is in alignment, then apply a back-up wrench to the union nipple.
12 Using a second wrench, tighten the union nut onto the threads of the union body.
13 Tighten the pressure connections between the pump body and the column assembly.
14 Tighten the screws securing the column to the drip pan.
15 Tighten the mounting screws securing the pump to the drip pan.
!
CAUTION: Deadweight testers should be bolted to a workbench or table to prevent tipping.
Union Nipple and Nut
Union Body
Union Nut
Union Nipple
Union Nut
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
To Next Page
Loading...
