BOSS Scoring™ System
Front Desk Reference Manual
Turning On and Off Non-Open Play Lanes 19
Checking In Leagues Through Interfaced Programs
Checking in leagues through interfaced programs requires that the league
has been set up in the Interfaced Programs module. See that manual for
details.
To check in a league through third party interfaced programs:
1. On the Main screen, select a lane range. The selected lanes are
highlighted.
Note: Keep in mind that the first lane in the range must be an odd number, and
you must select in pairs (2, 4, etc.).
2. Press League/Tourn Check-In. The Non Open Check-In screen
appears.
3. Press Interfaced Programs. The Non Open Check-In screen for
interfaced programs appears.
Note: On the left hand toolbar you will see Leagues and/or Tournaments
buttons in addition to the Interfaced Programs button. As each of these
programs has separate check-in screens, a check-in screen other than the
one for interfaced programs may appear first. You can press
(set as
default) to make this Interfaced Programs screen always appear first when
you access League/Tourn Check-In from the Main screen. If you do not
have the AMF Leagues or AMF Tournaments software loaded, the check-
in screen for interfaced programs will automatically appear first.
4. In the Interfaced Programs ID box, do one of the following:
• Type the ID number, and press
. Information pertaining to
the league appears in the middle of your screen.
OR
• Choose the ID number from the drop down list.
5. From the Play Mode drop down list, select the desired mode.
Before the bowlers arrive, you should select Hold, placing the lanes
on hold. After the league bowlers arrive, you should then access this
check-in screen again, (selecting the lanes, and pressing
League/Tourn Check-In, then Interfaced Programs), then select
Practice. When the league’s practice time is up, access this screen
once again, and select Play.
Hold
Turns on the scorer screen only. Lane is being held for
a league that is not yet ready to play.
Practice
Turns on the lane(s) and the scorer; choose With or
Without Pins. With Pins means that the Pinspotter