Amica PB4VI511FTB4S Series - Installation; Hob Installation Procedure

43
Installation of PB*4VI509*FT* hob
INSTALLATION
• prepareaplace(anopening)inthetabletopaccordingtodimensionsspeciedonthe
installation drawing (Fig. A),
• minimal clearance to be left between the appliance and the sides of the ne igh bo uring
cupboards is 50 mm,
• the installed plate is 50mm high,
• if the cooking plate is separated from the support cupboard by means of a horizontal pro-
tec ti ve plate, the clearance between the bottom of the enclosure of the cooking plate and
theprotectiveplatehastobeatleast25mmhightoensurefreeairow.
• cutasquareopening(withatleast80mmside)intherearpartoftheprotectiveplate(Fig.C),
• connect the plate to the mains according to the attached wiring diagram,
• matchthesectionofthemainscabletothepoweroftheplate(shouldbedonebyaqu-
aliedelectrician),
• remove dust from the top, insert the plate into the opening and press hard (Fig.B).
Fig. A
* dimensions valid for PB*4VI511 AFTB*S* hob
600 (750*)
600
50
500 (490*)
518
616 (770*)
50