EasyManua.ls Logo

Amica PB4VI511FTB4S Series - Control Panel and Zone Management

Amica PB4VI511FTB4S Series
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
51
OPERATION
Touch control sensor panel layout
• Immediatelyaftertheapplianceisconnectedtoelectricalmains,alldisplayswilllightup
briefly. Your induction hob is then ready for use.
• The induction hob is equipped with electronic touch control sensor fields, which are
operated by touching with a finger for at least 1 second.
• Touchingofasensorfieldisaccompaniedbyanacousticsignaltoacknowledge.
No objects should be placed on the sensor elds (this could cause an error). Touch
sensor elds should be always kept clean.
Switching on the cooking zones
Oncetheapplianceisswitchedonusingthe
on/offsensoreld(1), select a cooking zone
(3) within the next 20 seconds.
1. When a cooking zone selection sensor
eld(3) is touched (3), the relevant heat
setting indicator display shows 0and a
dot.
2. To select the desired heat setting, slide
yourngeracrosstheheatselectionsen-
soreld(2).
Switching on the appliance
To switch on the appliance touch and hold the
on/offsensoreld(1) for at least 1 second.
The appliance is switched on and the LED
pilot light comes on above the on/off sensor
eld(1) while all displays (3, 4) show 0and
decimalpointisashing.
If none of the sensor elds is to-
uched within 20 seconds, the ap-
pliance switches itself off.
Thetouchcontrolsensorpanelisequippedwithnewgeneration(3,4) „DIGI Select-Sensor”
sensorelds,wherethecookingzonedisplayisalsothecookingzoneselectionsensorand
the timer display is the timer selection sensor. Heat setting selection sensor (2) is a slider type
touch control sensor allowing selection of heat setting (1-9) and timer setting (1-99) by touching
andslidingyourngeracrossthemarkedarea(2):
- sliding right - increase the heat setting
- sliding left - reduce the heat setting.
It is also possible to select the heat setting directly by touching the appropriate part of the heat
settingselectionsensoreld(2).
4
3
3
1
1
2
3

Table of Contents

Related product manuals