Amiro U1 - Page 9

6
Face mask + device
● When using this device for stamping treatment (Intense/Gentle mode), ensure that the device head's surface fully contacts both the face mask and facial skin.
Avoid partial contact with the skin. [Figure 1]
● When stamping, make sure to follow the grid pattern precisely. [Figure 2, Figure 3]
● The device should be positioned with the smart sensor facing upwards when using the vertical grid. [Figure 4, Figure 5]
● The device emits energy once it detects the color blocks on the mask. To prevent potential injury, stamp the device steadily without moving or shaking it.
● Avoid continuous stamping. Adhere strictly to the grid sequence for stamping.
● Follow the recommended frequency of use: It is recommended not to use stamping treatments more than two times a week (including: Intense & gentle
mode).
Fully
pressed
Top contact only
Bottom contact
only
Stamp following the
grid pattern.
[Figure 2]
[Figure 1]
Single-side
Stamping without
following the grid pattern.
[Figure 3]
Smart sensor facing
upwards
[Figure 4]
Smart sensor facing
downwards
[Figure 5]