Ammann ARW 65 - Scraper Examination and Adjustment; Water Spray System Cleaning

6.6.5 Scrap ers
Ex am ine the scrap ers for wear and po si tion rel a tive to roller.
Ad just ment:
• Loosen hexa gon head screws (1).
• Shift the scrap ers (2) to wards the roller.
• The scrap ers should be set at a dis tance of 1.5 – 2 mm from
and par al lel to the roller.
• Tighten hexa gon head screw.
6.6.6 Wa ter spray ing sys tem
Clean wa ter tank when nec es sary:
• Dis man tle stop cock (1).
• Rinse out wa ter tank with pow er ful wa ter jet.
• Re fit stop cock, us ing new seal if nec es sary.
• Switch on the spray ing sys tem briefly in or der to rinse out the
pipework.
6. Main ten an ce
75