Repair 125
1201281 A | 24.07.2013
Fig. 10-2 Replacing the battery
NOTE The battery poles and terminals must be clean. If they are coated with a
(whitish or greenish) sulfur crust they must be cleaned.
10.1.2 Starting with another battery (jumpering)
1 Connect the red cable to the (+) terminals of both batteries.
2 Connect one end of the green or black cable to the (-) terminals of both
batteries.
3 Actuate the starter. Allow the engine to run.
4 Wait until the engine is idling smoothly and then disconnect the cables.
4.1 Begin with the (-) terminal.
Fig. 10-3 Jumpering the battery
To Next Page
Loading...
