AMOT C - Section 2 Introduction; 2.2 Safety; 2.3 Product support

5
Introduction
Doc No: OMMC00296 Revision: 2 – Sept 2020
Section 2
Introduction
2.1 Scope
This manual details the installation, operation and maintenance of
the AMOT Model C Valve range.
2.2 Safety
Certain operations within this manual are potentially hazardous and
could cause injury to personnel or damage to equipment if the
instructions are not carried exactly as described. Where a significant,
potential hazard exists, the following text appears immediately
before steps in the procedure that present a particular hazard:
WARNING
A Warning identifies a hazard that could cause injury to personnel.
The text of the warning describes the hazard and details the
precautions that must be applied before the next step of the
procedure is carried out.
CAUTION
A Caution identifies a hazard that could cause damage to
equipment. The text of the caution describes the hazard and
details the precautions that must be applied before the next step
of the procedure is carried out.
Note
A Note contains supplementary information that may be useful to the
Operator before the next step of the procedure is carried out.
2.3 Product support
All necessary settings and, where appropriate, alterations inside the
equipment are described in this Operating Manual. If any difficulties
arise during start-up, you are asked not to carry out any
unauthorized actions on the unit. You could endanger your rights
under the equipment warranty.
For spares and service support, call the telephone number listed on
the back cover of this Manual.