EasyManua.ls Logo

AMOT G Series - Safety; Maintenance; Product Support; Typographical Conventions

AMOT G Series
84 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
Introduction
Rev 5 – MAY 2019 OMMGGP00185
WARNING
A Warning identifies a step in a procedure that can cause injury to
people. The warning identifies the hazard and lists the precautions
that must be taken before the next step of the procedure is done.
CAUTION
A Caution identifies a step in a procedure that can cause damage to
equipment. The caution identifies the hazard and lists the precautions
that must be taken before the next step of the procedure is done.
Note
A Note contains more information that may be useful to the Operator and
can appear before or after a procedure step.
When installing, commissioning, operating or carrying out maintenance on the
unit, personnel must use safe working practices and observe all relevant local
health and safety requirements and regulations.
1.3 Product Support
All necessary settings are described in this manual. If any difficulties arise
during start-up, you are asked not to carry out any unauthorised actions on
the unit. You could endanger your rights under the equipment warranty.
For rapid spares and service support, call the telephone number listed on the
back cover of this manual.
1.4 Typographical Conventions
Footnotes
Where space in the text or figures to place a note is restricted, a footnote is
used. They consist of two parts:
A mark indicating which part of the text or figure is affected by the note.
This takes the form of a superscript number e.g. Abc
1
.
A note in smaller font at the bottom of the affected page beginning with
the corresponding number in the text (see bottom of page):
1
This footnote applies to the part of the text or figure, marked with a superscript number 1.

Table of Contents

Other manuals for AMOT G Series

Related product manuals