Need help?Do you have a question about the Ampcontrol ECD and is the answer not in the manual?
General| Manufacturer | Ampcontrol |
|---|---|
| Type | ECD |
| Mechanical Life | 10, 000, 000 operations |
| Operating Temperature | -40°C to +70°C |
| Storage Temperature | -40°C to +85°C |
| Electrical Life | 100, 000 operations at rated load |
| Insulation Resistance | 1000 MΩ min. at 500VDC |
| Vibration Resistance | 10-55Hz, 1.5mm |
| Operating Voltage | 12V DC, 24V DC, 110V AC, 240V AC |
Ensures safe operation by adhering to design parameters and manual instructions.
Details intrinsic safety requirements for installation and operation.
Procedures for checking equipment upon delivery against shortages or damage.
Guidelines for inspecting equipment for damage or specification deviations.
Proper indoor storage to ensure equipment protection and warranty validity.
Cautions to take when unpacking equipment, including environmental considerations.
Essential considerations and warnings for preventing incorrect or unsafe operation.
Adherence to specific practices to ensure safe operation and certificate validity.
Guidance on relay orientation for wiring requirements and label application.
Details the enclosure, dimensions, and mounting on a DIN rail.
Wiring diagram and terminal connection descriptions for the ECD relay.
Procedure to verify series resistance measurement for earth continuity.
Procedure to verify shunt resistance measurement for earth continuity.
Verifies the remote start function by repeating previous tests in remote start mode.
How the ECD measures series resistance and indicates open circuit faults.
How the ECD measures shunt resistance and indicates short circuit faults.
Details how to enable and operate the remote start mode.
Describes latching mode behaviour and manual reset requirements.
Step-by-step guide for manually resetting the unit after a fault.
Configuration options for remote start and latching modes via DIP switches.
Selection of trip level and trip time settings using rotary switches.
Explanation of status and healthy indicator LEDs.
Details on LED indications for various fault conditions and internal faults.
Procedure for starting the ECD, including auto-restart and manual start.
Routine external checks and visual inspections for serviceability.
Warning against user-serviceable parts; all repairs by Ampcontrol only.
Guidelines for environmentally responsible disposal of electronic equipment.
To Next Page
