Ampeg SVT-3 PRO Owner's Guide

Ampeg reserves the right to change specifications without notice.
Technical Specifications
OUTPUT POWER RATING 450 Watts RMS, 4 ohm load, 120VAC
275 Watts RMS, 8 ohm load, 120VAC
TONE CONTROL RANGE
Bass: ±12dB @ 50Hz
Midrange: ±15dB @ selected by Frequency control (220, 450, 800, 1.6k or 3kHz)
Treble: +14dB/-19dB @ 5kHz
GRAPHIC EQ LEVEL ±10dB
GRAPHIC EQ RANGE
33Hz: ±15dB
80Hz: ±8dB
150Hz: ±8dB
300Hz: ±8dB
600Hz: ±8dB
900Hz: ±8dB
2kHz: ±8dB
5kHz: ±9dB
8kHz: ±10dB
BRIGHT SWITCH +6dB @2kHz
ULTRA HIGH SWITCH +6dB @ 5kHz
ULTRA LOW SWITCH +2.5dB @ 50Hz
-12dB @ 560Hz
+1.5dB @ 5kHz
SIGNAL TO NOISE RATIO 75dB typical
FOOTSWITCH JACK Graphic EQ On/Off, Mute On/Off – tip = Mute, Ring = EQ
TUBE COMPLEMENT 12AX7 (4), 12AU7 (1)
POWER REQUIREMENTS
Domestic: 120VAC, 60Hz
Export: 230VAC, 50/60Hz; 100V 50/60Hz
DIMENSIONS 19/17.4”W x 4”H (with feet) x 15.5”D
Ampeg is proudly Made in America
©1999 SLM Electronics • 1400 Ferguson Avenue • St. Louis, MO 63133 U.S.A.
P/N 47-614-13 • 07/99
SVT-3 PRO Bass Amplifier
www.ampeg.com

Ampeg SVT-3 PRO Specifications

Power

output power rating at 4 ohm load	450 Watts RMS
output power rating at 8 ohm load	275 Watts RMS
power requirements domestic	120VAC, 60Hz
power requirements export	230VAC, 50/60Hz
power requirements Japan	100V 50/60Hz

Tone Control

bass control range	±12dB @ 50Hz
midrange control range	±15dB @ selected by Frequency control
treble control range	+14dB/-19dB @ 5kHz

Graphic Equalizer

graphic EQ level	±10dB
graphic EQ range 33Hz	±15dB
graphic EQ range 80Hz	±8dB
graphic EQ range 150Hz	±8dB
graphic EQ range 300Hz	±8dB
graphic EQ range 600Hz	±8dB
graphic EQ range 900Hz	±8dB
graphic EQ range 2kHz	±8dB
graphic EQ range 5kHz	±9dB
graphic EQ range 8kHz	±10dB

Switches

bright switch	+6dB @2kHz
ultra high switch	+6dB @ 5kHz
ultra low switch	+2.5dB @ 50Hz -12dB @ 560Hz +1.5dB @ 5kHz

Physical Characteristics

dimensions width	19/17.4”
dimensions height	4” (with feet)
dimensions depth	15.5”