1. 线缆准备：按生产需求选择合适尺寸的线缆; take right-sized cable according to production plan;
1 of 3
™
Rev. 2
®
2/3pos PowerLok 直头组装式插头安装规范(屏蔽款)
2/3pos PowerLok 180D Plug Assembly Specification(shielded)
Notice: 请严格按本指引实施装配作业！ please strictly follow this manual to proceed
plug assembly & cable harness operation job!
③SS ring1
不锈钢环1
②Rubber
ring胶圈
①end cap
尾盖
3. 拿取一套产品, 拆包, 拆分零件; take 1set plug
components, disassemble as on the right;
4. 取各1pcs的①尾盖, ②胶圈和③不锈钢环1, 从右边依次穿过线缆; take each 1pcs of ①end cap, ②rubber
ring and ③SS ring1, have cable insert through their holes from right in sequence;
5, 取1pcs的④不锈钢环2自左端穿过线缆, 并与③不锈钢环1按压在一起, 并剪去突出的多余的线头； take a
④SS ring2, load it to the cable end on the left, press together with ③SS ring1, cut off excessive braiding
wire;
⑤R4 holder with anti-rotation
chamfer 带止转切面的R4端子
④SS ring2
不锈钢环2
③SS ring1
不锈钢环1
2. 按如下尺寸剥离 线缆绝缘皮和外被; strip off
cable insulation and jacket as following
size on the right;
Doc NO.: AI-PL182&183-301-1
To Next Page
Need help?
General
