Need help?Do you have a question about the Amphenol SurLok Plus and is the answer not in the manual?
Align the master keyway of the receptacle and plug, then push the plug vertically.
Continue mating until an audible 'click' indicates the plug and receptacle are fully mated.
After powering down, press the button and pull the plug horizontally from the receptacle.
Do not deviate from the receptacle axis during unmating to avoid connector damage.
Insert the plug and receptacle into the positions shown in the figure.
Rotate the plug to adjust the outgoing cable direction to the desired position.
Align the key with the keyway and push the plug until a 'click' is heard.
After turning off power, press the button and pull the plug horizontally.
Do not deviate from the receptacle axis during unmating to avoid connector damage.
General| Product Type | Connector |
|---|---|
| Series | SurLok Plus |
| Manufacturer | Amphenol |
| Category | Cables and Connectors |
| Current Rating | 120 A |
| Contact Material | Copper Alloy |
| Housing Material | Thermoplastic |
| Operating Temperature | -40°C to +125°C |
| Ingress Protection | IP67 |
| Flammability Rating | UL94 V-0 |
| IP Rating | IP67 |
| Standards | UL |
| Application | Industrial |
| Number of Positions | 1 |
To Next Page