Amplicomms BigTel 1502 - Installing and Charging the Batteries

8
3.2. Installing and Charging the Batteries
1. Slide down to open the battery compartment cover.
2. Place the 2 batteries as indicated. Pay extra attention to direction of
Respect polarity.
3. Slide the battery compartment cover back.
4. Put the handset on the base and charge for 8 hours before using the
handsetforthersttime.Thehandsetwillgiveabeepwhenitisproperly
placed on the base or charger.
Notes:
1. Use only NiMH rechargeable batteries.
2. If the handset will not be used for a long time, disconnect and remove the batteries
to prevent possible leakage.
3.3. Connecting the Charger(s) (for Duo/Trio models)
Plug the power adapter into a 230Vac, 50Hz mains socket.
After rst time power up (base unit is connected to AC mains), welcome
mode (country) will appear on the screen:
e.g.
01-01-2021
e.g. 00:00