Need help?Do you have a question about the Amprobe AMP-210 and is the answer not in the manual?
General| Max Voltage (AC/DC) | 600 V |
|---|---|
| Max Current | 600 A |
| AC Current | Yes |
| DC Current | Yes |
| Resistance Measurement | Yes |
| Capacitance Measurement | Yes |
| Frequency Measurement | Yes |
| Data Hold | Yes |
| Backlight | Yes |
| Continuity | Yes |
| Frequency Range | 10 Hz to 10 kHz |
| Battery | 2 x AAA |
| Safety Rating | CAT III 600 V |
| Jaw Opening | 30 mm |
| Display | 3-3/4 digits 4000 counts LCD display |
Instruments conformity to Low-voltage and Electromagnetic compatibility directives.
Critical safety precautions to avoid electric shock and personal injury during operation.
Procedure for measuring alternating and direct current voltages using the clamp meter.
How to perform non-contact voltage detection using the NCV function of the meter.
Steps for measuring alternating and direct current with the clamp meter jaws.
Method for accurately measuring low AC or DC currents, especially for small conductors.
Instructions for measuring microamps, primarily for HVAC flame sensor testing.
Guide for testing resistance, checking continuity, and measuring diode forward voltage drop.
Procedure for measuring capacitance of electronic components using the meter.
How to measure temperature using the meter and a type-K thermocouple probe.
Steps for determining phase rotation direction for motors and mains supply.
Physical dimensions of the clamp meter models.
Weight specifications for different clamp meter models.
Maximum jaw opening size for conductor measurements.
Accuracy and range specifications for resistance measurements.
Accuracy and range specifications for capacitance measurements.
Specifications for testing diodes, including test current and voltage.
Specifications for measuring DC microamps on specific models.
Specifications for temperature measurement using type-K probes.
Specifications for precise AC current measurements at low levels.
Specifications for precise DC current measurements at low levels.
Specifications for precise AC+DC current measurements at low levels.
Accuracy and range specifications for AC current measurements across different frequencies.
Accuracy and range specifications for DC current measurements.
Specifications for DC+AC current measurements on specific models.
Specifications for frequency measurement functions.
Specifications for motor and mains phase rotation detection.
Specifications for non-contact voltage detection, including voltage ranges.
Step-by-step guide on how to replace the meter's batteries.
To Next Page
