- 17 -
8. Basic Operation
8.1 Powering ON/OFF the Device
The device will power ON/OFF automatically with the car
when engine starts/stops, and it can also be turned on by
PRESSING AND HOLDING the On/Off button until the
splash screen is displayed.
8.2 The Micro SD Memory Card
The device needs to operate with a Class10 micro SD
memory card. Make sure the card is placed into the slot in
the right position and press it further into the slot until it
completely locked in the place. To remove the SD card,
press firmly on the SD card further into the slot. There will
be a click and the SD card will pop out on release.
8.3 Charging the Device
You can charge the device with the included car charger
or with the most of USB ports.
The built-in battery is only intended to maintain device’s
operation after power been accidently cut off due to an
accident or crash. Note that, this battery is not for
- 18 -
long-term recording.
8.4 Navigating Menus
Press MENU to enter settings, press ‘UP’ or ‘DOWN’
buttons to find the setting you want to select or change
and then press OK button to select or confirm your
changes. Pressing MENU at any time will exit the menu
without saving changes.
8.5 Record Setup
8.5.1 Setting Video Resolution
The default setting is 1920x1080P/30fps (fps: Frames per
second). Choose the resolution of video recording:
1920x1080P/30fps (FHD), 1920x1080P/30fps (HD).
8.5.2 Setting Loop Recording
You can choose the setting to 1mins, 2 mins, 3 mins or 5
mins. The default setting is usually 3 mins, which means
every video clip will be last for 3 minutes.
Once the memory card is full, the camera will
continuously overwrite the oldest video clip recorded. To
protect a clip so that it will not be overwritten, press the
Emergency Lock button. And the emergency record
To Next Page
Loading...