ii
11830378_C
AMSCO® Rack Return Operator Manual
staff of well-equipped, qualified service technicians to provide this service, as well as expert repair services. Please contact
STERIS for details.
STERIS provides a line of accessories for use with this equipment. A STERIS representative will gladly review these with you.
Permissible Environmental Conditions
This equipment is designed to operate under the following conditions:
• Indoor use only;
• Relative humidity of 30% up to 80% non-condensing;
• Pollution Degree 2.
Pollution degree 2: Equipment must be installed in an environment where normally only non-conductive pollution occurs but
where occasional, temporary conductivity caused by condensation can be expected (as determined according to international
Standard EN/IEC 61010–1, Third Edition).
Seismic Anchorage System (Accessory)
A seismic anchorage system (based on California requirements) is available for high-risk seismic zones (Report #12026247)
Certification
The AMSCO Rack Return meets the applicable Safety Requirements for Electrical Equipment for Measurement, Control, and
Laboratory Use:
• Safety Standards:
◻ IEC 61010-1: 2010 Safety requirements for electrical equipment for measurement, control, and laboratory use - Part 1:
General requirements; Corrigendum 1 2011, Corrigendum 2 2013, 3rd Edition.
◻ UL 61010-1 Safety Requirements for Electrical Equipment for Measurement, Control, and Laboratory Use - Part 1:
General Requirements, 3rd Edition.
◻ CAN/CSA C22.2 No. 61010-1-12 Safety Requirements for Electrical Equipment for Measurement, Control, and
Laboratory Use Part 1: General Requirements, 3rd Edition.
• Standards Applied to Demonstrate Conformity to the Directives:
◻ CENELEC EN 61010-1: 2010 Safety requirements for electrical equipment for measurement, control, and laboratory use
- Part 1: General requirements, 3rd Edition.
◻ CENELEC EN 61326-1:2013 Electrical equipment for measurement, control and laboratory use - EMC requirements -
Part 1: General requirements
◻ CENELEC EN 55011:2009/A1:2010 Industrial, scientific and medical equipment - Radio-frequency disturbance
characteristics - Limits and methods of measurement
• Guidelines and Other Regulations Followed:
◻ California Building Standards Code (California Code of Regulations, Title 24) for Seismic Anchoring Requirements
◻ FCC PART 15, SUBPART B Class A – Unintentional Radiators
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
◻ Industry Canada ICES-001, Issue 5, Class A, Group 1 - Industrial, Scientific, and Medical (ISM) Radio Frequency
Generators
CAN ICES-001 (A) / NMB-001 (A)
• Governing Directive for the affixing of the CE mark:
To Next Page
Loading...
