What to do if Amsco Century is too long in charge?
If your Amsco Laboratory Equipment displays an alarm for 'Too Long In Charge', first silence the alarm. If the alarm repeats, check the steam supply valve and open it if it's closed. If the alarm continues to occur, contact service.
What to do if Amsco Century Laboratory Equipment is too long in evacuation?
If the Amsco Laboratory Equipment indicates 'Too Long In Evacuation', begin by silencing the alarm. Verify that the water supply valve is open; if closed, open the valve. Should the alarm persist, abort the cycle and contact service.
What to do if Amsco Century Laboratory Equipment is over sterilize temperature?
If your Amsco Laboratory Equipment shows an 'Over Sterilize Temperature' alarm, the first step is to silence the alarm. If the alarm continues, abort the cycle and contact service.
What to do if Amsco Century is too long in exhaust?
If the Amsco Laboratory Equipment displays an alarm for 'Too Long In Exhaust', silence the alarm. If the alarm recurs, contact service.
What to do if Amsco Century Laboratory Equipment is under sterilize temperature?
If your Amsco Laboratory Equipment indicates 'Under Sterilize Temperature', you should first silence the alarm. If the alarm persists, contact service.
What to do if Amsco Century Laboratory Equipment is too long in sterilize?
If your Amsco Laboratory Equipment signals 'Too Long In Sterilize', silence the alarm. Then, contact service for further assistance.
What to do if the door is unsealed on Amsco Laboratory Equipment?
If the Amsco Laboratory Equipment displays a 'Door Unsealed' alarm, silence it immediately, and then contact service.
What to do if Amsco Century has chamber pressure or temperature failure?
If your Amsco Laboratory Equipment displays an alarm for 'Chamber Pressure/ Temperature Failure', silence the alarm. After that, contact service.
What to do if Amsco Century has Input/Output Board #1 Communication Failure?
If your Amsco Laboratory Equipment displays an 'Input/Output Board #1 Communication Failure' alarm, you should first silence the alarm. Following this, contact service.
What to do if Amsco Century has load temperature probe failure?
If your Amsco Laboratory Equipment shows a 'Load Temperature Probe Failure' alarm, silence the alarm. Then, contact service for assistance.
General| Model | Century Series |
|---|---|
| Category | Laboratory Equipment |
| Door Mechanism | Automatic or manual, depending on model |
| Control System | Microprocessor-based |
| Construction | Stainless steel |
| Cycle Options | gravity, liquid |
| Sterilization Method | Steam |
| Safety Features | Over-temperature protection, door interlock |
To Next Page