Overview
18
NX-Series Controllers - WebConsole & Programming Guide
3. In the Workspace area, right-click and select Refresh Zero Conf ig List. The controller appears in the list of devices as shown in
FIG. 2:
4. Double-click the Master you want to access it in the WebConsole.
Accessing the Master requires valid login information. The browser will prompt you for User ID and Password before displaying
the configuration pages for the selected device.
Note that the serial number is appended to the name of the device.
After logging in, you can configure the device (changing IP settings, NetLinx settings, User settings, etc) via the pages in the
WebConsole (see the On-Board WebConsole User Interface section on page 34).
FIG. 2
Workspace bar (Zero-Config tab selected)
To Next Page
Loading...
Need help?
General
