NetLinx Programming
98
NX-Series Controllers - WebConsole & Programming Guide
IR/Serial SEND_COMMANDs (Cont.)
XCHM Changes the IR output pattern for the 'XCH' send command.
Syntax:
SEND_COMMAND <DEV>,"'XCHM-<extended channel mode>'"
Variable:
extended channel mode = 0 - 4.
Example:
SEND_COMMAND IR_1,"'XCHM-3'"
Sets the IR_1 device's extended channel command to mode 3.
Mode 0 Example (default): [x][x]<x><enter>
SEND_COMMAND IR_1,"'XCH-3'"
Transmits the IR code as 3-enter.
SEND_COMMAND IR_1,"'XCH-34'"
Transmits the IR code as 3-4-enter.
SEND_COMMAND IR_1,"'XCH-343'"
Transmits the IR code as 3-4-3-enter.
Mode 1 Example: <x> <x> <x> <enter>
SEND_COMMAND IR_1,"'XCH-3'"
Transmits the IR code as 0-0-3-enter.
SEND_COMMAND IR_1,"'XCH-34'"
Transmits the IR code as 0-3-4-enter.
SEND_COMMAND IR_1,"'XCH-343'"
Transmits the IR code as 3-4-3-enter.
Mode 2 Example: <x> <x> <x>
SEND_COMMAND IR_1,"'XCH-3'"
Transmits the IR code as 0-0-3.
SEND_COMMAND IR_1,"'XCH-34'"
Transmits the IR code as 0-3-4.
SEND_COMMAND IR_1,"'XCH-343'"
Transmits the IR code as 3-4-3.
Mode 3 Example: [[100][100]…] <x> <x>
SEND_COMMAND IR_1,"'XCH-3'"
Transmits the IR code as 0-3.
SEND_COMMAND IR_1,"'XCH-34'"
Transmits the IR code as 3-4.
SEND_COMMAND IR_1,"'XCH-343'"
Transmits the IR code as 100-100-100-4-3.
Mode 4: Mode 4 sends the same sequences as the 'CH' command. Only use Mode 4 with channels
0 - 199.
Mode 5 Example: <x><x><x><x><enter>
SEND_COMMAND IR_1,"'XCH-3'"
Transmits the IR code as 0-0-0-3-enter.
SEND_COMMAND IR_1,"'XCH-34'"
Transmits the IR code as 0-0-3-4-enter.
SEND_COMMAND IR_1,"'XCH-343'"
Transmits the IR code as 0-3-4-3-enter.
SEND_COMMAND IR_1,"'XCH-1343'"
Transmits the IR code as 1-3-4-3-enter.
Mode 6 Example: <x><x><x><x>
SEND_COMMAND IR_1,"'XCH-3'"
Transmits the IR code as 0-0-0-3.
SEND_COMMAND IR_1,"'XCH-34'"
Transmits the IR code as 0-0-3-4.
SEND_COMMAND IR_1,"'XCH-343'"
Transmits the IR code as 0-3-4-3.
SEND_COMMAND IR_1,"'XCH-1343'"
Transmits the IR code as 1-3-4-3.
To Next Page
Loading...
