mile display and kilometer display, which can be set in the settings. (See
Chapter 7 for the setting method.) The actual instrument speed is displayed in
only one unit. It is not possible to have two units at the same time. As shown in
Pic 6-4: (Pic 6-4 is only for explanation)
Pic 6-4
The total mileage, single mileage, riding time, maximum speed and average
speed can be switched and displayed. In the power-on state, the above
functions can be switched, and the display power-on defaults to the interface
before the last shutdown. To switch, press the key for 0.5 seconds to enter the
switch display selection of ODO->TRIP->TIME->MAX->AVG->ODO cycle. As
shown in the following Pic 6-5 interface mode: (The current 83Km is the total
mileage display, the other display is subject to actual.)
To Next Page
Loading...
