1.
Safety
Precautions
and
Warnings
To
prevent personal injury or damage to vehicles and/or the
scan tool, read this instruction manual first and observe the
following safety precautions whenever working on a vehicle:
Tum
the ignition off first.then connect 16-pin to plug.then turn the
ignition on.
Always perform automotive testing in a safe environment.
Do not attempt to operate
or
observe the tool while driving a vehicle.
Operating
or
observing the tool will cause driver distraction and
could cause a fatal accident.
Wear
safety eye protection that meets ANSI standards.
Keep clothing, hair. hands, tools, test equipment.
etc
.
away
from all
moving
or
hot engine parts.
Operate the vehicle
in
a well ventilated place: Exhaust gases are
Poisonous.
Put blocks in front
of
the drive wheels and never leave the vehicle
unattended while running tests.
Use
extreme caution when working around the ignition coil,
distributor cap, ignition wires and spark plugs. These components
create hazardous voltages when the engine is running.
Put the transmission in PARK (for automatic transmission) or
NEUTRAL (for manual transmission) and make sure the parking
brake is engaged.
Keep a fire extinguisher suitable for gasoline/chemical/electrical
fires nearby.
Don't connect
or
disconnect any test equipment while the ignition is
on
or
the engine is running.
Keep the scan tool dry, clean, free from oil/water
or
grease. Use a
mild detergent on a clean cloth to clean the outside of the scan tool,
when needed.
To Next Page
Loading...
