Anden A320V1 Specification Sheet

FEATURES
Control Onboard digital with diagnostics
Air supply orientation Horizontal
Filter 20"x22"x2" MERV 11
Refrigerant R410A
Coil type
Copper tube, Aluminum n
with ElectroFin
®
E-coat
Drain connection
*
¾" FNPT
P-Trap required Yes (Included)
Leveling feet Sold separately (Model #5789)
Hanging brackets Included
Duct Kit
Sold Separately (Part #5807)
Warranty
5 Years on all parts including
refrigeration system
*
Requires drain trap
SPECIFICATIONS
Capacity
(1)
PPD AT 80°/60%RH 320
Energy factor
(1)
2.9 L/kWh
6.0 pints/kWh
Voltage, Phase, Frequency 208–240VAC, 1 Phase, 60 Hz
Current draw
(amps)
(1)
11.1
Power (watts)
(1)
2,310
Btu/h
(2)
7,900
Power cord type and length
SJT, 6-20P, 10ft
Hardwire Field-congurable
Breaker size 20 amp
CFM 830
Dimensions:
Width: 32⅝"
Height: 24"
Length: 24¼"
Weight 180 lbs.
Operating range Temp/RH 60/50 to 85/80
(1)
Rated capacity and energy factor test done and current draw measured in accordance
with AHAM DH-1 2008 at 80°F/60% RH inlet air at 0.0 ESP, 208 VAC.
(2)
Total cooling load @ 80°F/60% RH.
PRINCIPLE OF OPERATION
The Anden Model A320V1 Dehumidier is designed to dehumidify
the air coming into the unit by passing the incoming air over an
evaporator coil to drop the air temperature below the dew point of
the air. Moisture is removed from the air and drained out of the unit
to a common oor or waste drain. The air is then reheated in the
condenser coil and exits the unit.
Dehumidication occurs until the set point is reached, then shuts
o until the control determines a need for operation.
APPLICATION
The Anden Model A320V1 Dehumidier is the perfect solution
for the precise management of humidity required in an indoor
growing environment.
High-Capacity Grow-Optimized
Dehumidifier
Model A320V1 | Specification Sheet
INCLUDED ITEMS
Control Model A77
Drain ttings
¾" MNPT x ¾” BARB,
¾" MNPT x ¾” Female pipe,
¾" FNPT x ¾” Female pipe,
¾" P-Trap
Drain tubing (length, ID) 10' – ¾" ID
Thermostat wire 30’ 20 gauge 4-wire
MODEL A77
Dedicated monitoring and control of
each dehumidier at canopy height
INCLUDED CONTROL
MODEL A77 SPECIFICATIONS
Electrical
Input voltage
and current
Voltage: 35VDC (supplied by
dehumidier control board)
Output Communication (RS485)
Control
Control range 35%–80% RH
Accuracy +/-5% RH
Dierential 3% RH
Low limit 40°F dew point
High limit 99°F dry bulb

Anden A320V1 Specifications

General

Brand	Anden
Model	A320V1
Category	Dehumidifier
Language	English