Anets A8 - Faq

69
3. FAQ
No.
Symptom
Reason
Method
1
Print model
dislocation
Synchronous
wheel/belt loose.
Tighten set screws
or fasten belt
2
Glitch with the
print model
Too high temp or
slicing problem.
Extruder temp is too
high and retracting
speed & distanse is
too small
3
Foamy print model
Low temp or not
smooth filament
entering.
Rise extruder temp
or check if brass nut
and bearing is good.
Replace a nozzle if
methods above can’t
solve the problem.
4
Printer model is
warped
Hotbed level isn’t
well adjusted.
Adjust hotbed
5
Unavaliable G-
code
tramsformation
Wrong
setting/wrong save
path
Choose right
machine type and
change the right
path
6
Software
installation failed
Different OS
Reset OS
7
Unusual temp
Broken temp sensor
Change a new one