70
F. Maintenance
Important maintenance tips:
1. maintenance of X,Y,Z axis: Add some lubricants on the rods to reduce
friction when the machine works noisy and a little bit shake.
2. Please refer to the USER MANUAL before printing, do preparation of
hot bed adjustment first.
3. When finished printing, the filament should keep sealing, avoid
moisture.
4. Preheat the extruder at the beginning of 2 nd time printing, let extruder
auto-push filament for a while.
5. Machine should do some regular maintenance, drop some lubricating oil
on thread rod, polished rod and bearings to avoid fatigue wear.
6. Do not let the fan and air-condition blow to the hot bed when printing.
7. Keep the working condition at “Temp:10-30℃，Humidity:20-70%”.
To Next Page
Loading...