Anglecare AC027 - Setting Up the Nursery Unit; Turning On Your Monitor

E
N
5
• If your cot does not have a solid, stationary, completely flat, firm surface including a spring
or slat base, place a hardboard between the cot base and the Sensor Pad, to ensure correct
operation. e hardboard support must measure at least 30 x 30 cm
(12” x 12”) and 6 mm (1/4”) thick. is hardboard support must be larger
than the Sensor Pad surface area
• e Sensor Pad functions with standard cot sprung and foam
mattresses and not memory foam (partial or full), hollow frame
construction mattresses and water beds. Please consult Angelcare if
unsure of mattress compatibility. e hardboard maintains a constant
pressure on the Sensor Pad, enabling it to detect the baby’s movements even when the baby
is at the edges of the cot
IMPORTANT
2 SETTING UP THE NURSERY UNIT
Sensor Pad
Place the
Nursery Unit at
least 1 metre
from the cot
3 TURNING ON YOUR MONITOR
Note:
• e Nursery Unit will emit a sound and flash blue
to confirm pairing with the Sensor Pad
• If the green light does not appear but the red
light is flashing; or if there are false alarms,
adjust the sensitivity level (STEP 3, TEST THE
SENSOR PAD)
CFO4B_ANGE_Manuel_AC027_ROW.indd 5 19-02-05 09:32