selecting a lower setting will not turn the heater ON).
• Turn the temperature control setting clockwise to increase temperature and
anticlockwise to decrease temperature. The heater will turn ON and OFF to maintain
the desired heating setting.
NOTE: There is a tip-over switch attached to the base of the heater. If the heater is not
placed on a flat surface or if it is knocked over, the power to the heater will shut down
automatically.
CLEANING AND MAINTENANCE
Before cleaning
‐When not in use or before cleaning, always disconnect the appliance from the
mains supply.
Cleaning
‐Cleaning can only be done when the unit is cooled. Do not immerse the whole unit in
water. Do not use harsh solvents on this unit.
‐ Wipe the exterior of the appliance with a damp cloth. Dry the unit completely with a
dry towel.
Damage check
‐Always check that the appliance is not damaged, is in good working order and
that all parts are secure. Check the power supply cord and plug regularly for
cuts or damage. For safety purposes, DO NOT use the heater if damage is found.
Store in a safe place
‐When not in use, store your appliance and the instructions manual together in
a safe and dry place.
NOTE: Always clean and store away your appliance with this instruction manual
when not in use.
NOTE: The heater may emit small amount of smoke and odour when used for the first time.
This is normal and caused by the lubricant on the heating element during the production
process. It is non-toxic. If the smoke and odour are excessive, use the heater in a ventilated
area. The smoke and odour should disappear after a few minutes of use.
To Next Page
Loading...
