EasyManua.ls Logo

anko FR-C21 - Thigh Massager; Demo; 9 Completion and Storage

anko FR-C21
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 12 of 16
To stop the massage fingers rotating at a particular spot, so as to apply heat in
one particular area, press the “LOWER” button when it reaches your desired
position and then ensure the Heat function has been turned on.
After approximately 15 minutes, the unit will automatically turn off.
8.2 Thigh Massager
The seat has a vibrating massager inbuilt to massage your buttocks and thighs.
To start the vibrating seat massager, press the “SEAT” button. The vibration
will start on low and the “L” indicator light will illuminate.
Press the “SEAT” button again and it will move to medium and the Mindicator
light will illuminate. This setting is stronger than low setting.
Press the “SEAT” button again and it will move to high and the “H” indicator
light will illuminate. This setting is stronger than medium setting.
Press the “SEAT” button again and the vibration will turn off.
After approximately 15 minutes, the unit will automatically turn off.
8.3 Demo
Press the “DEMO” button and the indicator light will illuminate.
The “FULL” indicator light will blink and the massager will go through a pre-set
routine with the back-massager fingers, heat and vibration massager.
It will automatically stop when the routine finishes in approximately 35 seconds.
9 Completion and Storage
After you have finished using the appliance, unplug the power adaptor and
disconnect from the appliance.
Store the appliance safely in its box and in a dry place.
Do Not wind the power adaptor cord around the appliance body as this will
damage the cord over time. Simply loop the cable and place next to the
appliance.

Related product manuals