Page 13 of 16
To clean the Ultrasonic Transducer, follow these steps:
• With the unit turned off and unplugged, remove the water tank.
• Using the small cleaning brush and clean water only (no detergents,
household cleaners or scouring pads etc.), brush any residue off the
transducer.
• When finished, rinse with clean cold water and tip down the sink.
• Dry the brush and store away for safekeeping.
8.2 Base and Water Tank
• With the unit turned off and unplugged, remove the water tank.
• Clean the outside surfaces with a clean, damp cloth and wipe dry. A
mild detergent may be used, however, DO NOT allow any detergent to
get onto the Ultrasonic Transducer.
IMPORTANT: Do not use flammable liquids, chemicals, abrasive
creams, steel wool or scouring pads for cleaning.
Never spray with liquids or submerge the unit in water or any other
liquid.
• Ensure the unit is completely dry before use.
9 Storage
• Switch off and unplug the unit.
• Empty the water tank and the water from the water trough and allow it
to completely dry, including the inside of the water tank.
• Coil the power supply cord loosely.
• Store in a cool dry well-ventilated area.
To Next Page
Loading...
