Check the Bag Suspender
The bag suspender should be checked every three to six months or if fiber values are higher than normal or
inconsistent. To check the Bag Suspender, follow the steps below.
1. Verify that you are using the NEW version of the Bag
Suspender Trays.
The NEW version of the trays has 9 holes in groups of 3
as shown in the picture to the right.
You CANNOT use the new and old bag suspender trays together.
2. Check the trays for melting.
The pictures shown are examples of extreme cases.
However, for proper operation you must replace trays
that show signs of melting or wear.
3. Check that the bottom tray is flat.
If the bottom tray is concave (see picture) the bag
suspender will catch in the vessel and melt.
Troubleshooting & Replacement Parts
The ANKOM Technology web site has the most current troubleshooting and replacement parts information.
Therefore, if you have any questions about the operation of your ANKOM
2000
Fiber Analyzer, or if you need
replacement parts, please visit our web site at www.ankom.com.
To Next Page
Loading...
