Need help?Do you have a question about the Anritsu ML2438A and is the answer not in the manual?
General| Measurement Speed | Up to 200 readings/second |
|---|---|
| Interface | GPIB, RS-232 |
| Weight | 3.5 kg |
| Frequency Range | 10 MHz to 110 GHz |
| Power Supply | 100 to 240 VAC, 50/60 Hz |
| Sensor Compatibility | Anritsu MA series power sensors |
| Display | LCD |
| Input Connector | N-type |
| Dimensions (W x H x D) | 214 mm x 88 mm x 350 mm (8.4 in x 3.5 in x 13.8 in) |
Lists the available ML243xA Power Meter models and their sensor channels.
Refers to a technical data sheet for additional options and accessories.
Details AC line, DC, and battery power specifications and requirements for the ML243xA Power Meter.
Provides instructions for charging, removing, and replacing the optional battery pack.
Illustrates and describes the N-Type calibrator and 12-pin sensor connectors on the front panel.
Details the various connectors located on the rear panel of the instrument.
Explains the numeric keypad, graphic LCD, soft keys, and power on/off button functions.
Describes controls for sensor data processing, including setup, mode, calfactor, and averaging.
Covers operating modes, display settings, rear panel functions, and battery state controls.
Outlines the steps to perform a standard power measurement using the ML243xA Power Meter.
Explains how to zero a sensor to remove DC offset and minimize measurement noise.
Details how to operate the ML243xA Power Meter remotely via a GPIB connection.
Describes the formats for data input and output, including numeric notations and string delimiters.
Provides an alphabetical listing of GPIB commands for ML24XXA native mode operation.
Information on how to obtain technical support and the details to provide.
Quick reference tables for ML24XXA native mode commands sorted by functional group.
To Next Page