Anritsu ML2438A - TR3 Trigger Free Run; TRGARM (Trigger Arming)

GPIB Operation ML24xxA Native Commands
ML2437A/38A OM/PM PN: 10585-00001 Rev. P 8-79
TR3 Trigger free run
TRGARM (Trigger arming)
Syntax: TR3
Remarks: Sets the ML243xA back into free run mode on both channels.
Related
commands:
TR0, TR1, TR2, *TRG, Group Execute Trigger (GET), GT0, GT1, GT2
Syntax: TRGARM <c>, <state>
c: 1, 2 or 1&2
state: ON or OFF
Remarks: Sets the readout trigger arming ON or OFF when in READOUT or
Power vs. Time mode.
Select channel 1, 2 or 1&2. Selecting 1&2 allows both channels to trigger
together on the same conditions without having to set up two sets of
trigger data.
If set to ON, the system first checks to see if the BNC sweep blanking
input is TRUE before it starts to trigger. If set to OFF, the system uses
the trigger source (TRSRC) to decide when to trigger.
TRGARM will return an execution error if trying to set trigger arming
ON when a display channel trigger source is already set to EXTTTL, as
they both use the same BNC input.
Query: TRGARM? <c>
TRGARM <c>,<state>
The TRG type commands return the trigger state of the selected channel
if the channel is ON. This depends on the settings of the “link triggers”
flag and the current mode of the sensor on the selected channel. If the
channel is OFF, the stored trigger state of the channel is returned.