23
Automation Software Selection Guide
The MP1900A can execute the following receiver tests using automation software in combination with a real-time oscilloscope. Refer to the next
page for option configurations required by the MP1900A. Refer to the Selection Guide (MP1900A-E-Z-1) for the supported combination of real-time
oscilloscopes and automation software.
Interface Type Compliance Test Item
PCIe Gen 3/4/5
Base Spec Stressed Eye Test
CEM Spec
Transmitter initial Tx Equalization
Transmitter Link Equalization response (Tx LEQ)
Receiver Link Equalization (Rx LEQ)
PLL Bandwidth
USB3.2 Gen1/2
Transmitted Eye Test
Receiver Jitter Tolerance Test
USB Type-C
(USB4, Thunderbolt3)
Receiver Test
SJ Margin Test
Amplitude Margin Test
SAS-3/-4 Receiver Jitter Tolerance Test
DP1.4 Sink Jitter Tolerance Test
To Next Page
Loading...
