7
Full Automation
Full Automation Software
Automation software for automating receiver tests of high-speed serial bus interfaces controls the MP1900A (PPG/ED, noise signal source, variable
ISI channel) and real-time oscilloscope to automate calibration of signals required for complex operations, Jitter Tolerance tests, and creation of
reports. The high-reproducibility, easy measurements greatly reduce the work load of test engineers.
Features
• Controls each measuring instrument to simplify calibration, measurement conditions settings, and test execution
• Calibrates test signal and executes receiver test with high reproducibility
• Automates standards-compliant Jitter and amplitude Pass/Fail evaluations
• Selectable Various Oscilloscope
Selectable Various Oscilloscope
Real-time oscilloscopes from the main makers can be used in combination with the MP1900A to calibrate test signals, helping cut capital investment
costs by making efficient use of owned assets.
Refer to the Selection Guide (MP1900A-E-Z-1) for the combination of supported real-time oscilloscopes and automation software.
Customers’ Real-Time Oscilloscope
MP1900A
Vendor K
High Performance BERT
Automation Software
Selectable Various Ocilloscopes
To Next Page
Loading...
