ORIGINAL OPERATING INSTRUCTIONS - ELECTRIC DRIVE FOR PEDELECS
42
13. START-UP
As soon as the battery is charged and firmly latched in the holder, the drive
system is ready for use.
13.1 SWITCHING ON / OFF
When using a down tube battery you switch ON the electric drive by short
pressing the button on the capacity indicator of the battery ( few se-
conds after you pressed the button display show drive is ON ).
press
100% 20%40%60%80%
If the bicycle is not used, the electric drive and display switch OFF
automatically after 15 minutes ( only when the output current of the
battery is less than 100mA).
When using a carrier battery you switch ON the electric drive by using the
ON / OFF switch at the battery. For switching OFF the electric drive you
have to use the same switch.
ON / OFF
To Next Page
Loading...