space around the machine, and make sure there is no flammable gas or material nearby;
Step 2. Fill the fluid box with Antari approved bubble fluid;
Step 3. Plug the machine to the power outlet. Please read the technical label on the back of the machine and make
sure the power outlet has the correct rated voltage for the machine;
Step 4. Turn on the power, the internal bubble wheel and fan will active and start to produce bubble. Turn off the
power to stop.
Step 5. To turn off the power, please make sure the machine is not operating. If you will not use the machine a
long period of time, please unplug the power cord.
8. Filling Bubble Fluid
Ensure your bubble machine is unplugged from the main electrical supply before attempting to open the housing.
To help avoid accidental exposure to dangerous live AC mains voltage, two safety screws are fitted that require a
screwdriver to remove. Once these are removed, the finger screws can be undone by hand (see photo below).
Once the screws are removed, the lid of the housing can be carefully swung upwards, as shown below. Make sure
not to spill any of the bubble fluid inside the unit.
The fluid box is designed to fit only one way around. Make sure you insert it correctly, as shown below, with the
lower edge facing into the machine.
***Always check bubble fluid level.
***Please make sure that the bubble wands are completely covered with bubble fluid.
***Do not overfill the bubble fluid – stop 5cm below the box top edge to avoid overflow and internal damage.
***Only use Antari Bubble Fluid – the machine cannot run on water only or other uncertified fluid.
To Next Page
Loading...
