Antari B-100X - BCR-1 Wireless Remote (Optional); Service and Maintenance; Technical Specifications

6
12. BCR-1 Wireless Remote (Optional)
BCR-1 Wireless Remote is an optional accessory for B-100X Bubble Machine, it included a receiver and a wireless
transmitter. It’s ready to use, no pairing necessary, please see instruction below;
1. Plug the receiver to the back of the machine;
2. Press BLUE button to start bubbling and press RED button to stop bubbling.
** Signal range is approximately 50m in open area, it may vary depending on actual situation on site.
** If you encounter any problem, please contact your local Antari dealer for assistant.
13. Service and Maintenance
DANGER
Disconnect the power cord before starting maintenance operation!
 Always keep the machine clean.
 Can use an air compressor, a vacuum or a soft brush to remove the dust on the machine.
 Can use a slightly damp cloth to clean the casing.
 Before store or after use the machine, please make sure the fluid box is empty and dry.
 It is recommended to run the machine at least once a month in order to maintain its best performance and
output condition.
 Excessive dust and build up liquid residue will reduce the performance and cause overheat.
14. Technical Specifications
B-100
B-100X
Input Voltage
US Model : AC 100-120V, 50/60Hz 0.5A
EU Model : AC 220-240V, 50/60Hz 0.5A
Rated Power
120V 30W
240V 32W
Fluid Consumption
8.3 ml/min (100% Output)
Operating Time
1.4 hrs (100% Output)
Fluid Box Capacity
0.7 Liters (0.18 gallon)
Compatible Fluid
Antari BL Bubble Fluid
Ambient Temp. Range
5°C – 40°C (41°F – 104°F)
Control Methods
Manual
Manual、Timer (Optional)、Cable Remote
(Optional)、Wireless Remote (Optional)
Interface
N/A
DMX Channel
N/A
Included Accessories
Hanging Bracket
Optional Accessories
N/A
Z-10 Cable Remote、BCT-1 Timer Cable
Remote、BCR-1 Wireless Remote
Dimension
L 341 W 170 H 172 mm (L 13.43 W 6.69 H 6.77 inch)
Weight
4.2 kg (9.26 lbs.)