Antari FT-200 - WTR-20 Wireless Remote; Z-3 Cable Remote

6
depends on actual condition, it may vary.
 If effective range is significantly shorter, please change battery.
 W-2 wireless transmitter has 4 buttons, each function as follow:
W-2 Wireless Transmitter
W-2 Wireless Receiver
(Already Installed on the Machine)
Button
Function
[A]
Start Fogging
[B]
Stop Fogging
[C]
Increase Fog Output
[D]
Decrease Fog Output
10.2 Pair & Unpair
Each receiver can pair up to 5 transmitters, please follow the steps below to pair or unpair the transmitter;
Step 1. Press and hold the [TIMER] knob for 3 seconds to enter menu;
Step 2. Rotate the [TIMER] knob to [Wireless Detect];
Step 3 Start to pair or unpair the transmitter according to the instruction.
11. Z-3 Cable Remote (Optional)
Z-3 Cable Remote is an optional accessory for FT-200 Fire Training Fog Machines, please see instruction below;
1. P lug the cable remote to the connector on the back of the machine, red indicator light on (Power);
2. Press the switch (Orange Indicator Light On); turn the knob to adjust the output to start fogging;
3. Press the switch (Orange Indicator Light Off), or turn the knob to far left to stop fogging.
** If you encounter any problem, please contact your local Antari dealer for assistant
12. Service and Maintenance
DANGER
Disconnect the power cord before starting maintenance operation!
 Always keep the machine clean and dry.
 Can use air compressor, vacuum or a soft brush to remove the dust on the machine.
 Can use a slightly damp cloth to clean the casing.
 Before store the machine, please make sure the machine is completely cool down to avoid moisture inside
causing malfunction.
 It is recommended to run the machine at least once a month in order to maintain the machine’s best
performance and output condition.
 Excessive dust and build up liquid residue will reduce the performance and cause overheat.