Antari M-7X - Service and Maintenance

11
112-127
128-143
144-159
160-175
176-191
192-207
208-223
224-255
Chase 8
Chase 9
Chase 10
Chase 11
Chase 12
Chase 13
Chase 14
Chase 15
Channel 7
DMX Value Range
Function
Chase Speed
0-255
0-255 step per min
Channel 8
DMX Value Range
Function
Master Dimmer
0-255
0-100%
Channel 9
DMX Value Range
Function
Strobe
0-255
1-20 Hz
Fluid
Use Antari FLC water-based Fluid for the best effect for the M-7X Fogger. The machine is
tested and calibrated with this liquid to get the best output performance. Warranty will be
voided if any other type of liquid is used, improper use of liquid may lead to machine failure
and malfunction.
Service and Maintenance
․ Do not allow the machine to become contaminated.
․ Remove dust from air vents with air compressor, vacuum or a soft brush.
․ Only use a damp cloth to clean the casing.
․ Before storing run distilled water through the system to help avoid condensing the
pump or heater.
․ It is recommended to run the machine on a monthly basis in order to achieve best
performance and output condition.
․ Excessive dust, liquid and dirt built up will degrade performance and cause
overheating.