Antari W-508 - Service and Maintenance; Technical Specifications

7
10.1 W-1 Wireless Transmitter & Receiver
 Battery：27A 12V
 Effective Range：The effective range is approximately 50
meter, depends on actual condition, it may vary.
 If effective range is significantly shorter, please change battery.
 W-2 wireless transmitter has 4 buttons, each function as follow:
W-1 Wireless Transmitter
Button
Function
[A]
Start Fogging
[B]
Stop Fogging
W-1 Wireless Receiver
(Already on the Machine)
10.2 Pair
Each receiver can pair up to 5 transmitters, please follow the steps below to pair;
Step 1. Turn on the machine, W-508 with green indicator light/W-510 with orange indicator light will flash for 15
seconds. Within this time period, press button A on the W-1 transmitter to pair with the machine. When
indicator light stop flashing, means it’s paired;
Step 2. Please repeat Step 1 to pair multiple transmitters.
*If exceed 15 seconds, turn the power off and on again.
11. Service and Maintenance
DANGER!
Disconnect the power cord before starting maintenance operation!
 Always keep the machine clean and dry.
 Can use air compressor, vacuum or a soft brush to remove the dust on the machine.
 Can use a slightly damp cloth to clean the casing.
 Before store the machine, please make sure the machine is completely cool down to avoid moisture inside
causing malfunction.
 It is recommended to run the machine at least once a month in order to maintain the machine’s best
performance and output condition.
 Excessive dust and build up liquid residue will reduce the performance and cause overheat.
12. Technical Specifications
W-508
W-510
Input Voltage
US Model: AC 100-120V, 50/60Hz 7.0A
EU Model: AC 220-240V, 50/60Hz 3.5A
US Model: AC 100-120V, 50/60Hz 8.5A
EU Model: AC 220-240V, 50/60Hz 4.5A
Rated Power
800W
120V 1000W
240V 1070W
Warming-up Time
2 minutes (approx.)
13 minutes (approx.)