Need help?Do you have a question about the Antec HCG-520M and is the answer not in the manual?
Introduction to the Antec HCG M series power supply, highlighting performance and efficiency features.
Details the industrial-grade safety circuitry (OCP, OVP, UVP, SCP, OPP, SIP) for computer protection.
Presents table detailing output voltage, load max, regulation, and ripple & noise for the PSU.
Explains the modular connectors on the PSU, including 5-pin and 10-pin jacks for cable management.
Provides contact information for technical support, including phone numbers, emails, and social media links.
Lists Antec's official addresses and contact fax numbers for corporate inquiries.
General| Model | HCG-520M |
|---|---|
| Maximum Power | 520W |
| Form Factor | ATX |
| Fans | 1 |
| Cooling Fan | 120mm Double Ball Bearing Fan |
| PFC | Active PFC |
| Main Connector | 20+4Pin |
| PCI-Express Connector | 2 x 6+2-pin |
| SATA Power Connector | 6 |
| 4-Pin Peripheral Connector | 4 |
| 4-Pin Floppy Connector | 1 |
| Modular | Semi-Modular |
| Input Voltage | 100 - 240V |
| +12V Output | 40A |
| Over Voltage Protection | Yes |
| Under Voltage Protection | Yes |
| Over Power Protection | Yes |
| Over Temperature Protection | Yes |
| Short Circuit Protection | Yes |
| Over Current Protection | Yes |
| No Load Operation | Yes |
| Input Current | 8A-4A |
| Input Frequency Range | 47Hz - 63Hz |
| Dimensions | 150mm (W) x 86mm (H) x 160mm (D) |
| Series | HCG M |
| Type | ATX 12V v2.32 / EPS 12V v2.91 |
To Next Page
