Pure2 User Manual 8
4. Enter the ‘Enhancements’ tab and make sure all enhancements are disabled.
5. Enter the ‘Advanced’ tab and choose any of the available “2 channel, 24-bit” modes.
Click ‘OK’ to close the window.
6. Back in Sound settings, click 'Device Properties' under 'Input'. Then, click 'Additional
Device Properties'. Enter the 'Enhancements' tab and disable all enhancements. Click 'OK'
to close the window.
Tips
● If you are experiencing interruptions or failure when using your DAW and trying to
playback audio from your OS at the same time, make sure that the device sample
rate matches the one of your DAW session.
● You can disable the device and enable it again from the ‘Playback’ tab to refresh the
driver. This will be similar to disconnecting and re-connecting your device, which
makes Windows reset the playback configuration of the applications you are using.
● In some cases, disabling the ‘Exclusive mode’ functionality from the ‘Advanced’ tab
in ‘Playback’ Properties might help when running multiple playback applications at
the same time.
● Disabling the 32kHz sample rate isn’t mandatory, but it might help in general.
Further Reading
Antelope Audio Knowledge Base - Windows 10 Optimization
To Next Page
