Need help?Do you have a question about the Anton Paar TCU 1000 and is the answer not in the manual?
General| Brand | Anton Paar |
|---|---|
| Model | TCU 1000 |
| Category | Measuring Instruments |
| Language | English |
Details the front panel components of the TCU 1000, including the controller, buttons, and LEDs.
Describes the connectors and ports located on the rear panel of the TCU 1000 for various connections.
Provides general procedures for installing the TCU 1000, including rack or table housing options and environmental considerations.
Step-by-step instructions for mounting the TCU 1000 into a 19-inch rack using the supplied guide bars.
Information on connecting the TCU 1000 to mains power, including voltage, frequency, and fuse specifications.
Instructions for connecting the TCU 1000 to the HTK 1200 camera using heater output and temperature sensor cables.
Details on connecting the flow controller to the designated 'WATERFLOW CONTROL' connector on the rear panel.
Instructions for connecting the sample spinner to the 'SAMPLE SPINNER' connector on the rear panel.
Guide to connecting a computer via the RS 232 C serial port, including pin assignments and default communication parameters.
Explains how to operate the TCU 1000 using the integrated EUROTHERM controller on the front panel.
Details the functions of the 7 keys on the EUROTHERM controller for navigating menus and controlling the instrument.
Describes the EUROTHERM controller's user interface, including temperature display, status, and parameter fields.
Explains how the current temperature at the sample holder is displayed and potential sensor error indications.
Details the meaning and usage of parameters like SP, WSP, OP, SPR, and SRL in the controller.
Describes the status field indicating normal operation, standby (SBY), or loop break (LBR) conditions.
Explains how to access different levels of controller settings, potentially requiring a password for authorized personnel.
Describes how to use the heater button to stop heating, enter standby mode, or select gain shed (SCH).
Instructions on using the speed control knob to adjust the sample spinner's rotation speed.
Addresses problems related to heating, listing possible causes like fuse issues or defective heating, and reset procedures.
Covers problems with temperature measurement, including sensor errors ('S.br.') and reset procedures.
Guides on interpreting error messages from the EUROTHERM controller and referring to its dedicated manual for details.
Troubleshoots issues with the cooling water cycle, flow controller, and standby mode, including potential causes and remedies.
To Next Page