AOC e2262Vwh - Monitor Hotkeys; Button Functions Overview

18
You can click “RESET” to set the e-Saver to its default settings like below.
Question
Answer
e-sensor no power
1. Into the factory mode，set Burn in to OFF;
2. Set e-sensor to ON.
interface show e-sensor
The detecting range is too near or far and the User is far away the monitor, reset the
examination area.
it can’t your monitor to
turn off or dark while you
are away
1. Please do not block the e-Sensor on the LOGO, which is located on the left of AOC
logo.
2. The detecting range is too far or the things blocks monitor , reset the examination area.